We Drove a Manual Chevy Corvette C8, and It’s Exactly What America’s Sports Car Needs

The Drive ·

We Drove a Manual Chevy Corvette C8, and It’s Exactly What America’s Sports Car Needs

Tremec threw a six-speed manual in a C8 and built the Corvette that Chevy won't. But the price to replicate this yourself will make your eyes water. The post We Drove a Manual Chevy Corvette C8, and It’s Exactly What America’s Sports Car Needs appeared first on The Drive .

The Chevrolet Corvette C8 was a big pivot for the Bowtie. It wasn’t just the first Corvette with the engine behind the driver; it was also the first to offer a dual-clutch automatic transmission—and only a dual-clutch automatic transmission. After decades of front-engine development, Chevy faced the daunting cost of building a pair of new transaxles (one manual, one automatic) that could mate with a mid-engine car.

Needless to say, developing two gearboxes wasn’t (and still isn’t) in GM’s budget . Now, I wasn’t in the room, and I can’t say exactly how that all played out (and those who were won’t say), but the smart money says that when faced with the choice between either pleasing a vanishingly small group of enthusiasts and winning comparison tests against far more expensive equipment, executives simply chose the latter.

A marketing decision, one might argue, but one that produced a particularly excellent and very capable Corvette. But many of us would still gladly give up a few tenths in the quarter-mile or lap time for the simple enjoyment of operating a manual.

Enter Tremec, the company that built America’s most beloved six-speed gearbox —the transmission employed in GM’s own performance cars, including both Blackwings (RIP CT4) and the also-departed Camaro. And despite rumors to the contrary, its manual C8 development car is quite real . How do I know? Well, I just drove it.

Tremec invited me (along with several potential customers) to sample its whole suite of transmissions at a new (so much so that it’s not on Google yet), private track outside Howell, Michigan, called Motorsports Gateway . There, I was handed the proverbial keys to the Peitz Performance C8 race car equipped with Tremec’s new manual gearbox—and I was basically told: “Good luck, don’t hit anything.” It’s only a one-of-one, right? No pressure.

This was very much a track build. The fit and finish inside is, well, nonexistent. The selector sticks right out of the spot where you’d normally find the storage cubby and automatic gear selector. The car’s also fully caged and fitted with a full harness.

The car’s incompletely extended to another key item: there’s virtually no adjustment in the race car’s seating position. That’s fine for whoever normally drives it, but I can confidently tell you it’s somebody with longer legs than my 5-foot-7-inch frame. Heel-toe gets a little awkward when you can’t touch the floor with either (or brace yourself in corners), so suffice it to say I wasn’t in a position (pun intended) to push things too hard. And considering we were on a green track on a November afternoon in Michigan, Tremec was probably thankful that I was slightly hamstrung.

Peitz didn’t have to make significant alterations to the car itself to fit the gearbox. The tunnel had to be cut to install the clutch pedal hardware, naturally, but the manual gearbox otherwise sits exactly where the stock dual-clutch box would—no fancy mating hardware required. Surprisingly, the C8’s pedal box has plenty of room for the clutch. Even with the third pedal, it feels roomier than a last-gen Camaro’s.

If you’ve driven a front-engine car with the TR-6060 six-speed, working the transaxle will feel a bit odd. That’s because the shifter is remotely mounted; if you look carefully at the above shot of the Peitz car’s interior, you can see one of the cables running aft toward the gearbox. With most front-engine, rear-wheel drive cars (including those equipped with the standard TR-6060 and its predecessors), the selector is mechanically connected directly to the transmission assembly; there are no cables to manipulate.

As a result, the transaxle is a bit less precise and snick-snicky to operate than its front-engine cousin. It’s also a bit less notchy. Some may find that appealing, as it tends to smooth off some of the Tremec’s rougher edges. Others may miss the front-engine variant’s more mechanical feel. The only solution would be to move the engine forward or the shifter rearward. The former gets you a C7; the latter would mean bolting the driver’s seat roughly where the C8’s engine is mounted—as if it wasn’t already hard enough for me to reach those pedals.

But that trade-off is a small price to pay to get a manual gearbox. The gearbox’s monetary cost, however, isn’t quite so trivial. Between the cost of the Corvette and Tremec’s gearbox, building a manual C8 has a price tag that rivals a showroom-spec Z06. You’re talking about $75,000 for the gearbox alone. Tremec says that price will come down as volume increases. OEMs are interested, Tremec told us, and by that we don’t necessarily (and certainly not exclusively) mean General Motors. Yes, the gearbox was engineered to fit in the C8, but we’ve been told other automakers want a high-torque manual transaxle. No names were named, but you can probably think of a few potential takers.

Apropos of nothing, does anybody need a not-so-gently used, 42-year-old kidney? Asking for a friend.

Got a story tip? Let us know at tips@thedrive.com

The post We Drove a Manual Chevy Corvette C8, and It’s Exactly What America’s Sports Car Needs appeared first on The Drive .

Источник: The Drive